PMDX Forum

General Category => Parallel Port breakout boards, motherboards, and dedicated accessories => Topic started by: lthomps on February 01, 2016, 11:00:54 AM

Title: Terminal Plug Connect for PMDX-132
Post by: lthomps on February 01, 2016, 11:00:54 AM

I have a legacy PMDX-132 motherboard that I am using as a 3axis currently and I am adding a 4th axis.  Does anyone know where I can get 4pin terminal plugs for it.  I have no idea where I got the existing plugs I have from.  I purchased the 4pin plugs from PMDX, but the pin distance is too short.  They need to be 5mm. 

Title: Re: Terminal Plug Connect for PMDX-132
Post by: Bob at PMDX on February 01, 2016, 11:54:34 AM

The only 4-pin screw terminal connectors that we sell are for the PMDX-340.  Are you talking about the 4-pin connector that you install on the Geckodrive unit for the motor wires?  If so, these came with the PDMX-132.  I can look around the lab and see if we still have any.  If so, we can send them back to you with your PMDX-422 board(s) when you send them in for repair.

Bob

Title: Re: Terminal Plug Connect for PMDX-132
Post by: lthomps on February 01, 2016, 12:06:18 PM

Yep, those are the ones I am referring to.  Thanks