PMDX Forum

General Category => Parallel Port breakout boards, motherboards, and dedicated accessories => Topic started by: Bill I on June 22, 2016, 07:13:25 PM

Title: PMDX 126 Outputs Enabled LED problem
Post by: Bill I on June 22, 2016, 07:13:25 PM

I followed the instructions to the letter.  At initial power ? on After the E-Stop turned off the Outputs Enables LED turned on and turned off and the status LED started blinking.
I also have the PMDX 107 attached to the PMDX 126. How do I get Outputs Enables LED to stay on or is this because I have the PMDX 107 attached?

Thanks
Bill I

Title: Re: PMDX 126 Outputs Enabled LED problem
Post by: Steve Stallings on June 22, 2016, 07:44:35 PM

The STATUS led should be blinking a code to explain what is wrong.

The chart of status codes is in section 9.1 of the users manual here:

http://www.pmdx.com/Doc/PMDX-126_Manual_19.pdf