1
General Discussion / Re: Sherline CNC Conversion Electronics PMDX Selection Help
« on: January 30, 2016, 10:36:49 PM »
Steve,
I purchased the PMDX-122 as suggested I have everything wired up and I have the pins set in mach3. The steppers are engaged, but I am not getting any movement from the jog functions in Mach3. Any further troubleshooting tips?
Thanks,
Lewis
I purchased the PMDX-122 as suggested I have everything wired up and I have the pins set in mach3. The steppers are engaged, but I am not getting any movement from the jog functions in Mach3. Any further troubleshooting tips?
Thanks,
Lewis