1
SmartBOB controllers and dedicated accessories / PMDX 407 connected to pmdx 422 How to configure analog speed control (Mach4)
« on: September 21, 2015, 10:20:45 AM »
Hi I purchased the pmdx 407 speed control to use the analog output for speed control. I currently have a manual rotary potentiometer that is connected to my spindle drive (Driveblok).
I have connected the board to my 422 board in accordance with the instructions and have been able to verify that the board receives power and works in PWM mode.
I need some advice on how to configure Mach4 to communicate with the 407 analog outputs.
Thanks,
Romesh
I have connected the board to my 422 board in accordance with the instructions and have been able to verify that the board receives power and works in PWM mode.
I need some advice on how to configure Mach4 to communicate with the 407 analog outputs.
Thanks,
Romesh