Show Posts
1
SmartBOB controllers and dedicated accessories / Problem config probe input
« on: October 10, 2017, 10:30:20 AM »
When I try to configure an input on my PMDX-424 as PROBE1 for Mach4 i got a warning message.
If I try to run probing in Mach4 I got message "ERROR: No contact with probe"
See my config and the warning message in the attached pics.
What have I missed and/or done wrong?
I run Mach4 Version: 4.2.0.3481 and PMDX SmartBOB-USB Plug-In Version: 0.52.254
If I try to run probing in Mach4 I got message "ERROR: No contact with probe"
See my config and the warning message in the attached pics.
What have I missed and/or done wrong?
I run Mach4 Version: 4.2.0.3481 and PMDX SmartBOB-USB Plug-In Version: 0.52.254