Show Posts
1
SmartBOB controllers and dedicated accessories / PMDX-424 with PMXD-407
« on: April 23, 2018, 12:34:52 AM »
Howdy All,
New to installing PMDX products, but happy with how well I managed to get all my axis working.
I do have a problem with the 407: It does not seem to respond to the Spindle On button in Mach4.
I am missing some pieces of information to help me fault find:
1) When I select the Spindle to "Fwd" on the Mach4 screen, should the LED on the 407 light up regardless of any VFD connection?
2) When I power up the board, should the same above mentioned LED flash twice and then stay extinguished?
3) How can I tell if Mach4 is sending the command to the 407?
4) In the attached picture, is that the proper configuration for the 424 with the 407?
...any other hint :)
Thanks very much for your help!
New to installing PMDX products, but happy with how well I managed to get all my axis working.
I do have a problem with the 407: It does not seem to respond to the Spindle On button in Mach4.
I am missing some pieces of information to help me fault find:
1) When I select the Spindle to "Fwd" on the Mach4 screen, should the LED on the 407 light up regardless of any VFD connection?
2) When I power up the board, should the same above mentioned LED flash twice and then stay extinguished?
3) How can I tell if Mach4 is sending the command to the 407?
4) In the attached picture, is that the proper configuration for the 424 with the 407?
...any other hint :)
Thanks very much for your help!