Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - madiaz91911

Pages: [1]
1
SmartBOB controllers and dedicated accessories / E-Stop does not work
« on: October 30, 2015, 04:20:05 PM »
I connected an e-stop to the 422 board. Connected switch to pin 10 and then the other side of the switch to the "GND".  This configuration does not work. Anything else I need to do? I also see an e-stop on the J10 side. That one has a jumper on it. What that doing?

Pages: [1]