Messages

1

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: Estop Light Stays on

« on: December 31, 2015, 02:59:22 PM »

Bob,
Awesome.  It's he simplest things in life that cause us the most grief.
Thanks,
Greg

2

Parallel Port breakout boards, motherboards, and dedicated accessories / Estop Light Stays on

« on: December 30, 2015, 10:39:41 PM »

After powering up the new 126 the e-stop led will not go out.  The power led is lit, the RST led lights up and then goes out and the Outputs enabled led is lit but the e-stop will not go out.  There are 3.74 VDC with the e-stop jumper off and 0 volts with it on.  All dip switches are set to off.  Pin J1 is on Pin 1, J2 is on Pin 14, J3 is off, J4 is off, J5 is off J6 is normal.  The additional blue, black and brown wires in the picture will be for future home / limit switches.  These are only wired into a terminal block and not to any sensors. Any help would be greatly appreciated.  Thanks, Greg