Messages

1

Parallel Port breakout boards, motherboards, and dedicated accessories / Need help wiring a PMDX 107 to a Delta VFD-M

« on: July 25, 2016, 10:33:58 AM »

These are the wires from PMDX107.  I do not know where to connect these wires to the Delta VFD.



PMBX 107                      

Rev/Dir            
Fwd/Run            
COM               
Aref               
Aout                        
Agnd                
               

Delta VFD-M

Forward/Stop      MO
Rever1se/Stop      M1
Reset                    M2
Multi-Step  1        M3
Multi-Step  2        M4
Multi-Step  3        M5
Common Signal   GND

2

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: 126-134 Motor #4 will not move

« on: June 29, 2016, 08:20:40 PM »

Have solved the problem with some help from Steve.  Both motors are on the X axis went onto Mach Config then down to Slave Axis and made A the slave to the X drive then go into Homing / Limits and reversed A drive direction.  When two motors are on the same axis the motors must run in opposite directions or the axis locks in place.

3

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: 126-134 Motor #4 will not move

« on: June 28, 2016, 11:20:32 PM »

I swapped the pins on the 4th axis and the motor still will not move.

4

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: 126-134 Motor #4 will not move

« on: June 28, 2016, 09:04:07 PM »

Hi Steve
Attached is the XML file you requested.
Thanks Bill I

5

Parallel Port breakout boards, motherboards, and dedicated accessories / 126-134 Motor #4 will not move

« on: June 28, 2016, 06:36:54 PM »

126-134 problem set all step and direction with the assistance from Steve thanks again Steve.  The problem is that #4 drive does not move but it has power.  The motor does move in the test mode and when I plug into another driver it will move.  Could it be a problem with the ribbon cable between the 126 and the 134 also I am running a USB smooth stepper.
Thanks Bill I

6

Parallel Port breakout boards, motherboards, and dedicated accessories / PMDX 126 Outputs Enabled LED problem

« on: June 22, 2016, 07:13:25 PM »

I followed the instructions to the letter.  At initial power ? on After the E-Stop turned off the Outputs Enables LED turned on and turned off and the status LED started blinking.
I also have the PMDX 107 attached to the PMDX 126. How do I get Outputs Enables LED to stay on or is this because I have the PMDX 107 attached?

Thanks
Bill I