1
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: Pmdx-120 Breakout Board problem maybe
« on: September 02, 2018, 09:04:28 AM »
I found if I keep the controls at 67 to 72 degree's It works fine if I go lower it malfunctions or higher I was routeing when the temp in room went above 72 and it started acting up. I have a fan with a filter system blowing into my control cabinet for years now but this would show up ever so often hot and cold more so hot. So I was right in thinking this could be the cause and not the UFO or EMI interference as I have been told.
Next question I'm not experienced with replacing chips would it be better to buy a new board or is it a simple job. Thanks
Next question I'm not experienced with replacing chips would it be better to buy a new board or is it a simple job. Thanks