1
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: G214 with PMDX-126
« on: May 26, 2017, 01:42:17 AM »
This is where I am with the diagram right now. I would like to use the following features of the PMDX-126 and G214
FAULT
RESET
ENABLE
I would also like to still be able to use my motor enable/disable switch to be able to disengage my motors if I need to push one of the axis out of a tripped limit.
FAULT
RESET
ENABLE
I would also like to still be able to use my motor enable/disable switch to be able to disengage my motors if I need to push one of the axis out of a tripped limit.