Show Posts
1
Generic Spindle interfaces, I/O boards, Misc boards and panels / spindle Precision Matthews PM-25MV
« on: October 03, 2018, 08:46:27 PM »
hi,
I need to interface a Masso controller (0-10V I believe) to the PM-25MV. This is a BLDC system controlled by a pot. I probably need an isolated analog to analog circuit with a couple of relays to control enable as well as forward/reverse.
Does anyone have a solution that will work for me?
thanks,
mike
I need to interface a Masso controller (0-10V I believe) to the PM-25MV. This is a BLDC system controlled by a pot. I probably need an isolated analog to analog circuit with a couple of relays to control enable as well as forward/reverse.
Does anyone have a solution that will work for me?
thanks,
mike