1
Parallel Port breakout boards, motherboards, and dedicated accessories / X axis vibrating when home activated
« on: October 06, 2018, 03:15:02 PM »
Tried searching forum first for similar issues with no luck.
Using PMDX 126 and 134 with warp9 ESS for 6 months on Windows 10 with no problems.
Now x axis stepper is vibrating in place and jogging opposite directions sporadically.
Replaced or swapped control cables, stepper and gecko drive.
Updated all drivers and mach 3.
I have attached my XML if it helps.
Would love some help with this.
Maybe you have encountered this problem before? Possibly the Warp9 ESS?
Thanks!
Tom
Using PMDX 126 and 134 with warp9 ESS for 6 months on Windows 10 with no problems.
Now x axis stepper is vibrating in place and jogging opposite directions sporadically.
Replaced or swapped control cables, stepper and gecko drive.
Updated all drivers and mach 3.
I have attached my XML if it helps.
Would love some help with this.
Maybe you have encountered this problem before? Possibly the Warp9 ESS?
Thanks!
Tom