Messages

1

Parallel Port breakout boards, motherboards, and dedicated accessories / PMDX-126 and probing trigger, error

« on: July 23, 2022, 01:14:41 PM »

I have 4 G203v's, a pmdx-126 and mach 3 right now. Currently it was working fine, except for an occasional zero level trigger miss. Now I see the pmdx trigger but it never gets to the Mach3 pin 11 to trigger zero found. the board (pmdx triggers, well the little led goes on) but MAch3 doesn't see it is there something I need to redo to make it work? (yeah yeah, I know upgrade to another software, that's not going to happen yet since I haven't found one I like as well as mach3 that's not "dedicated to a specific type of card or computer like Mach4 or UCCNC.)