Show Posts
1
Show and Tell / Re: Cnc knee mill
« on: September 29, 2020, 11:15:00 AM »
Hello,
I found your post from 2016 about your jetmatic mill conversation. I’m working on converting one just like it. Any advice you can give me now that you have done a conversation on one of these machines? I’m looking to make this as seamless as possible. Any recommendations are appreciated.
Thanks,
Dave C
I found your post from 2016 about your jetmatic mill conversation. I’m working on converting one just like it. Any advice you can give me now that you have done a conversation on one of these machines? I’m looking to make this as seamless as possible. Any recommendations are appreciated.
Thanks,
Dave C