Messages

1

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: Trouble with using the pmdx-107 to control spindle with mach 3

« on: November 04, 2022, 11:47:18 AM »

is there a vfd that would be easier to set up with this configuration?
I am using the 126 combined with the 107.

2

Parallel Port breakout boards, motherboards, and dedicated accessories / Re: Trouble with using the pmdx-107 to control spindle with mach 3

« on: October 18, 2022, 01:05:16 PM »

I just redid all the connections from the vfd to the pmdx-107, and now the k1 relay on the pmdx-126 turns on when I put the pmdx-107 in test mode. But the spindle still does not turn on

3

Parallel Port breakout boards, motherboards, and dedicated accessories / Trouble with using the pmdx-107 to control spindle with mach 3

« on: October 14, 2022, 12:47:54 PM »

I was recently thrown into an uncompleted cnc mill conversion. I do not have that much knowledge of electronics, so bear with me.
The mill I am working on uses the pmdx-126 as the main board and has the pmdx-107 installed as well. The 107 is supposed to control the vfd which is a Danfoss vlt microdrive.
The dip switch settings on the 107 are as follows:
1:off
2:off
3:off
4:off
5:off
6:off
The switch settings for the 126 are as follows:
1:on
2:off
3:off
4:off
5:off
6:off
7:on
8:off
The jumper pin settings on the 126 are as follows:
JP1: multimode
JP2: multimode


Any help is appreciated