1
General Discussion / Re: 424 relay
« on: February 15, 2023, 05:52:35 PM »
sorry i did mean m5
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / Re: 424 relay
« on: February 15, 2023, 08:54:48 AM »
it just hangs on the first g5 there is more code after that. i am using this as a plasma table and i am using the spindle start and stop as the torch control on and off. is there a better way of doing this?
3
General Discussion / 424 relay
« on: February 15, 2023, 07:36:27 AM »
hello i am new to cnc i have a 424 i am having a problem with the output relay. it will turn on with the m3 command but will not turn off with the m5 command. the g code gets stuck on the g5 command and the relay stays on. is there an output signal for spindle off that i am not seeing?
Pages: [1]