Hello, I have PMDX-126 and not finding good information online how to wire this to my AC servo drives.
I have an industrial CNC router that I am retrofitting to Mach3 controller. Just about have everything buttoned up and rewired regarding e-stop, homes, limits, enable, fault etc.. but I am not getting any motion.
Yes, the drives do work (they move in serial cable setup mode) and they are enabled when I have attempted.
This is a pinout of C8 (a serial connector on the top on drives) It is used when in GEARING MODE set to PULSE/DIRECTION.
PIN 1 - A+
PIN 2 - A-
PIN 3 - (DC common)
PIN 4 - B+
PIN 5 - B-
PIN 6 - (SHIELD)
PIN 7 - (reserved)
PIN 8 - I+
PIN 9 - I-
Servo Drive: SERVOSTAR S: SR03200-2G203B
Servo Motor: GOLDLINE: M-203-B-23
Picture attached is how I was told by a user on another website to connect to PMDX-126. Tried, but nothing happened.
HELP!