« previous next »
Pages: [1]

Author Topic: E-Stop does not work  (Read 4297 times)

madiaz91911

  • Posts: 1
    • View Profile
E-Stop does not work
« on: October 30, 2015, 04:20:05 PM »
I connected an e-stop to the 422 board. Connected switch to pin 10 and then the other side of the switch to the "GND".  This configuration does not work. Anything else I need to do? I also see an e-stop on the J10 side. That one has a jumper on it. What that doing?
« Last Edit: October 31, 2015, 12:10:17 AM by Bob at PMDX »
Logged

Steve Stallings

  • Administrator
  • Posts: 530
  • www.PMDX.com/Images/Avatar120.jpg
    • View Profile
Re: E-Stop does not work
« Reply #1 on: October 30, 2015, 04:35:17 PM »
The jumper is installed at the factory so that the board will run if you do not connect an E-Stop switch.

When you do connect a normally closed E-Stop switch, you must remove the jumper in order for it to work.
Logged
Steve Stallings
www.PMDX.com
Pages: [1]
« previous next »