« previous next »
Pages: [1]

Author Topic: Probe installation  (Read 4780 times)

hernandd58

  • Posts: 22
    • View Profile
Probe installation
« on: April 11, 2016, 07:28:39 PM »
What screw terminal do I use for a touch probe for my Z motor. Any suggestions.

Thanks
Logged

hernandd58

  • Posts: 22
    • View Profile
Re: Probe installation
« Reply #1 on: April 11, 2016, 07:29:31 PM »
Sorry it for a PMDX 424 board
Logged

Bob at PMDX

  • Administrator
  • Posts: 368
    • View Profile
    • PMDX
Re: Probe installation
« Reply #2 on: April 11, 2016, 10:32:15 PM »
In general, any of the PMDX-424's inputs will work.  However, I would recommend using one of the 8 isolated inputs on connectors J16 and J17 (i.e. SmartBOB Input1 through Input8).  These provide extra protection "just in case", since the touch probe wiring goes over to the machine instead of, say, switches on a panel.

Bob
Logged
Engineering Hell: Everything's right and nothing works.
Bob's Corollary: If everything's right and nothing works, double check your assumptions.
Pages: [1]
« previous next »