PMDX 126 Outputs Enabled LED problem

[Bill I]

I followed the instructions to the letter.  At initial power ? on After the E-Stop turned off the Outputs Enables LED turned on and turned off and the status LED started blinking.
I also have the PMDX 107 attached to the PMDX 126. How do I get Outputs Enables LED to stay on or is this because I have the PMDX 107 attached?

Thanks
Bill I

[Steve Stallings]

The STATUS led should be blinking a code to explain what is wrong.

The chart of status codes is in section 9.1 of the users manual here:

http://www.pmdx.com/Doc/PMDX-126_Manual_19.pdf