« previous next »
Pages: [1]

Author Topic: Charge Pump pin in the Mach configuration changes on its own  (Read 4274 times)

MitchB

  • Posts: 6
    • View Profile
Charge Pump pin in the Mach configuration changes on its own
« on: November 02, 2015, 04:04:17 PM »
If I perform the following steps, the charge pump pin number in the Mach output configuration changes from Pin 1 to Pin 17.  This is with XP Pro and Mach 4.2.0.2763 and PMDX-411 v0.31.147

1. Start with charge pump assigned to pin 1 and enable Mach.
2. Enter plug in configuration and change something - like spindle assertion level.
3. Exit configuration screen.
4. Charge pump pin has now changed to pin 17 in the Mach configuration screen

I don't know if this is a Mach or a plug-in issue.
Logged

Bob at PMDX

  • Administrator
  • Posts: 368
    • View Profile
    • PMDX
Re: Charge Pump pin in the Mach configuration changes on its own
« Reply #1 on: November 02, 2015, 05:11:33 PM »
Thank you for posting the steps to reproduce this.  Despite my response in your other thread, I have indeed replicated this problem.  Now I gotta go figure out why.  Stay tuned.

Bob
Logged
Engineering Hell: Everything's right and nothing works.
Bob's Corollary: If everything's right and nothing works, double check your assumptions.

Bob at PMDX

  • Administrator
  • Posts: 368
    • View Profile
    • PMDX
Re: Charge Pump pin in the Mach configuration changes on its own
« Reply #2 on: November 03, 2015, 04:39:56 PM »
Found the problem.  Look for a new plug-in release probably/hopefully tomorrow (Nov 4th).
Logged
Engineering Hell: Everything's right and nothing works.
Bob's Corollary: If everything's right and nothing works, double check your assumptions.
Pages: [1]
« previous next »