Hello, I have a first generation shopbot that was converted, and is now being run by a pmdx-126, with a pmdx-107, and pmdx-134 controlling my g230v stepper drivers. I recently had the hardrive fail on the control computer i was using, and have started fresh with new os, and new load of mach 3. I have been able to get my e-stop, and limit switches set up, and communicating with the computer, but have not been able to get my motors to step.
When I set everything back up, I used the provided pin locations from the 134's manual (step 3,5,7 and direction 2,4,6), but so far have not been able to get the motors to step. Any help or insight you guys might have would be greatly appreciated!